Msi X2-109 v1 Uživatelský manuál stáhnout pdf (Strana 61)

Configuration Commands 4-9

4.7 Configuration Commands

You can use the commands in this section to create storage

configurations.

4.7.1 Add RAID 0, 1 or 5 Configuration

Use the command in Table 4 . 1 1 to add a RAID level 0, 1, or 5

configuration to the existing configuration on the selected adapter. For

RAID level 10, see Section 4.7.3, “Add RAID 10 Configuration.”

Important

: LSI recommends that you do not use both SAS and SATA

drives in the same array. Using different drive interfaces in

this way could cause decreased performance, an increased

error count, and decreased MTBF.

Description The RAID driver maintains a volatile circular list of 100 events, which is deleted at

reboot. The following command options are available:

• -GetEventlogInfo: Displays overall event information such as total number of

events, newest sequence number, oldest sequence number, shutdown sequence

number, reboot sequence number, and clear sequence number.

• -GetEvents: Gets event log entry details. The information shown consists of the

total number of entries available at the firmware side since the last clear and

details of each error log entry. Start_entry specifies the initial event log entry

when displaying the log.

• -GetSinceShutdown: Displays all the events since last adapter shutdown.

• -GetSinceReboot: Displays all the events since last adapter reboot.

• -IncludeDeleted: Displays all events, including deleted events.

• -GetLatest: Displays the latest number of events, if it exists. The event data is

written to the file in reverse order.

• -Clear: Clears the event log for the selected adapter(s).

Table 4.10 Event Log Management (Cont.)

Table 4.11 Add RAID 0, 1, or 5 Configuration

Syntax CmdTool –CfgLDAdd -R0|-R1|-R5[E0:Sn] [ -szXXXXXXXX [-szYYYYYYYY

[...]]] [-strpszM] [-Hsp[E5:S5,...]] [–afterLdX] -aN

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 131 132

Žádné komentáře

Msi X2-109 v1 Uživatelský manuál Strana 61