Msi X2-109 v1 Uživatelský manuál stáhnout pdf (Strana 58)

4-6 MegaCLI Command Tool

4.4.3 Set Adapter Properties

This command sets the properties on the selected adapter(s). For

example, for {RebuildRate -val}, you can enter a value between 0

percent and 100 percent. (The rebuild rate is the percentage of the

compute cycles dedicated to rebuilding failed drives.) At 0 percent, the

rebuild is done only if the system is not doing anything else. At 100

percent, the rebuild has a higher priority than any other system activity.

The default rebuild rate of 30 percent is recommended.

Use the command in Table 4 . 4 to display or set adapter properties.

4.4.4 Display Specified Adapter Properties

Use the command in Table 4 . 5 to display specified properties on the

selected adapter(s).

Table 4.4 Set Adapter Properties

Syntax CmdTool –AdpSetProp {RebuildRate -val} | {BgiRate –val}|{CCRate –val}|

{CoercionMode –val} -aN|-a0,1,2| -aALL

Description Sets the properties on the selected adapter(s). The possible settings are:

• RebuildRate: Rebuild rate. Values: 0 to 100.

• BgiRate: Background initilization rate. Values: 0 to 100.

• CCRate: Consistency check rate. Values: 0 to 100.

• CoercionMode: Drive capacity Coercion mode. Values: 0 = None; 1 = 128 Mbytes;

2 = 1 Gbyte. You can set the Coercion mode only when there is no existing

configuration on the adapter.

Table 4.5 Display Specified Adapter Properties

Syntax CmdTool –AdpGetProp RebuildRate | BgiRate | CCRate | CoercionMode

-aN|-a0,1,2|-aALL

Description Displays the properties of the selected adapter(s).

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 131 132

Žádné komentáře

Msi X2-109 v1 Uživatelský manuál Strana 58