MSI MS - 9211 Specifikace stáhnout pdf (Strana 12)

2-8

MS-7187 M-ATX Mainboard

Installing DDR2 Modules

1. The DDR DIMM has only one notch on the center of module. The module will only

fit in the right orientation.

2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until

the golden finger on the memory module is deeply inserted in the socket.

3. The plastic clip at each side of the DIMM slot will automatically close.

Reminds You...

You can barely see the golden finger if the module is properly inserted in the

socket.

Volt

Notch

DIMM1 (Ch A) DIMM2 (Ch B) DIMM3 (Ch A) DIMM4 (Ch B) System Density

256MB~1GB 256MB~1GB 512B~2GB

256MB~1GB 256MB~1GB 512MB~2GB

256MB~1GB 256MB~4GB 512MB~2GB

256MB~1GB 256MB~1GB 512MB~2GB

256MB~1GB 256MB~1GB 256MB~1GB 256MB~1GB 1GB~4GB

GREEN

ORANGE

GREEN

ORANGE

Reminds You...

-Dual-channel DDR works ONLY in the 5 combinations listed in the table shown

in the previous page.

-Please select the identical memory modules to install on the dual channel, and

DO NOT install three memory modules on three DIMMs, or it may cause some

failure.

-Always insert the memory modules into the GREEN slots first, and it is strongly

recommended not to insert the memory modules into the ORANGE slots while the

GREEN slots are left empty.

-Due to the South Bridge resource deployment, the system density will only be

detected up to 3+GB (not full 4GB) when each DIMM is installed with an 1GB

memory module.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Žádné komentáře

MSI MS - 9211 Specifikace Strana 12