MSI K7T266 Pro2-A Manuál s instrukcemi stáhnout pdf (Strana 31)

Chapter 2

2-14

Hard Disk Connectors: IDE1 & IDE2

The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/

133 controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/

100/133 function. You can connect up to four hard disk drives, CD-ROM,

120MB Floppy (reserved for future BIOS) and other devices. These connec-

tors support the provided IDE hard disk cable.

IDE1 (Primary IDE Connector)

The first hard drive should always be connected to IDE1. IDE1 can

connect a Master and a Slave drive. You must configure second hard

drive to Slave mode by setting the jumper accordingly.

IDE2 (Secondary IDE Connector)

IDE2 can also connect a Master and a Slave drive.

IDE2IDE1

TIP:

If you install two hard disks on cable, you must configure the

second drive to Slave mode by setting its jumper. Refer to the

hard disk documentation supplied by hard disk vendors for

jumper setting instructions.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 75 76

Žádné komentáře

MSI K7T266 Pro2-A Manuál s instrukcemi Strana 31